Related Manuals for Antec P180B Fan
Summary of Contents for Antec P180B Fan
- Page 1 P180B User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario...
-
Page 2: Installing The Motherboard
At Antec, we continually refine and improve our products to ensure the highest quality. So it’s possible that your new case may differ slightly from the descrip- tions in this manual. This isn’t a problem; it’s simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct. - Page 3 If it does not match this Intel standard, please contact your motherboard manufacturer for an adapter. You may also call Antec customer support at (800) 22ANTEC (North America) or +31 (0) 10 462-2060 (Europe) to purchase a USB adapter. This adapter will allow you to connect the front USB to your motherboard on a pin-by-pin basis.
-
Page 4: Connecting The Audio Ports
If you intend to connect the front FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE 1394 connector, please call Antec customer service at (800) 22ANTEC (North America) or +31 (0) 10 462-2060 (Europe) to purchase an adapter. This adapter will allow you to connect the front IEEE 1394 port to the external-type connector. - Page 5 3. There are two HDD trays inside the cage. Squeeze the metal clips on each side of a tray and slide it out. 4. Mount your hard drive to the drive tray with the special screws provided. Don’t over-tighten the screws since that could decrease the grommets’ ability to absorb vibration and noise.
-
Page 6: Installing The Power Supply
Fan-Only connector found on some Antec power supplies. A fan-controlled-device regulates the fan speed by varying the voltage to the fan. The voltage may start as low as 4.5V to 5V. Connecting a Tricool™... - Page 7 These two fans are mounted so that the air is blowing out of the case. The top fan comes with a spoiler to mount on the top of the case. To install the spoiler: 1. With the spoiler open end facing the rear of the case, carefully align the tabs of the spoiler with the notches on the case.
- Page 8 3. Clip the fan into position as shown We strongly recommend NOT installing the optional fans unnecessarily since they will create additional fan noise. However if you insist, we recommend using Antec 120mm TriCool™ fans and setting the speed to low.
-
Page 9: Technical Support: Us & Canada
Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2006 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China. Version 1.0.1 02/21/2006...