Navy_CRX

Hi everyone i got a turbo for free from work and was wondering how much power it could make and what its worth. It is a garrett with a t4 flange that says .70ar on the hot side.
any help is appricated
thanks in advance
eddie

Navy_CRX

correction it says .70ar on the compressor side and 1.05 on the hot side

Gunmetal_B20_Hatch

iTrader: (9)

need to know measurements of wheels...

Navy_CRX

sorry it took a while but this is what i got

Comp. Inducer-91mm housing says A/R.83 M24
exducer-71mm has 7 large blades with 7 small blades between them

turbine. couldn't get the measurements cause mu calipers weren't large enough but roughly 82mm 11 blades housing says, its in a line like this heading down from the turbine inlet flange.
A/R
1.05
M1
G2

Navy_CRX

this link looks just like mine but no one identified it there either

http://www.rx7club.com/showthread.php?t=945559

met

I am not sure what it is exactly, but from the graphs just comparing them to the one you have its in the range between a gt35 and gt37. If you do some searches and find out exactly what to measure on the wheels you can find out a lot more. I think its has something to do with the ratio between the lager diameter and smaller diameter of both compressor and turbine wheels. The numbers you were talking about on the housings from what I understood has to do with the size on the housings and not the wheels themselves.

TheShodan

iTrader: (14)

that's a little larger than even a GT37

met

Had a feeling you would jump in and set me straight Shodan

TheShodan

iTrader: (14)

Nah. I'm not exactly sure what that is off-hand either. It might be better to post pictures at several angles.

Navy_CRX

here are some pics

vwbased

have a nice day